FAQs
Traralgon Paints
Automotive & Industrial Coating Specialists
FAQs
What should I do about paint that has dried to a soft, cheesy consistency?
Read more: What should I do about paint that has dried to a soft, cheesy consistency?A paint film that has dried in this condition is mechanically weak and needs to be completely removed. Carefully clean…
What causes blister formations in coating?
Read more: What causes blister formations in coating?Blisters in any coating form as the result of isolated areas of poor/insufficient adhesion of the coating to the surface…
Is there a simple way of dealing with powdery surfaces on outside paintwork?
Read more: Is there a simple way of dealing with powdery surfaces on outside paintwork?Powdery or chalky old paintwork is caused by the paint film wearing away due to exposure to weather. This natural…
Can I effectively treat mould and algae on exterior surfaces prior to decorating?
Read more: Can I effectively treat mould and algae on exterior surfaces prior to decorating?Yes, there is a very effective treatment for these types of vegetable growths, which are most likely to occur in…
I get a foaming and frothing effect when using a roller. What causes it?
Read more: I get a foaming and frothing effect when using a roller. What causes it?You’re using the wrong type of roller. For instance, if you use a sponge roller to apply water-based paints, air…
How can I quickly test for rotten wood?
Read more: How can I quickly test for rotten wood?Simply run a knife blade across the grain. This will only make a small indentation on sound timber, but on…
What is the best way to prepare a surface where the colour has faded?
Read more: What is the best way to prepare a surface where the colour has faded?Surfaces where the colour has faded due to exposure from ultraviolet sunlight should be thoroughly cleaned down to remove all…
Bubbles on the paint surface have appeared after using a foam roller. How can I correct this?
Read more: Bubbles on the paint surface have appeared after using a foam roller. How can I correct this?Foam rollers should not be used with water based paints. If you already have this problem there are two solutions.…
What are the main reasons for paint staining and discolouration on plaster?
Read more: What are the main reasons for paint staining and discolouration on plaster?Past water leaks or burst water pipes can cause water staining. Before repainting, ensure that the leak has stopped and…
Can you safely paint over denatured wood?
Read more: Can you safely paint over denatured wood?No. Failing to completely remove wood that has been exposed to weather and sunlight is a common cause of paint…
What’s causing the little spots/cissing of unpainted areas when I’m painting?
Read more: What’s causing the little spots/cissing of unpainted areas when I’m painting?The paint can’t adhere to the surface because of contamination by oil, grease, wax or polish. So the paint draws…
What causes adhesion failure on metal?
Read more: What causes adhesion failure on metal?Adhesion failure on metal substrates, resulting in blistering, flaking/delamination and corrosion, is usually due either to surface contamination or poor…
Need expert advice?
Can’t find what you need to get the job done?
